It's Finished
Here it is all finished.
|
 |
I sprayed some matt clear over the whole
project.
|
 |
Here you can the two lug nuts that I cut on my lathe here.
|
 |
There are eight, 10-32 bolts that are welded to those guide plates.
|
 |
The front consists of some 7/16" bolts welded together that fasten to
the lock-nuts.
|
 |
Here you can see what those five small screws look like and where they
are used.
|
 |
A view from within.
|
 |
It sits nice and low.
|
 |
The setscrews are used to hold the gears on that axle and allows them to
spin.
|
 |
Those roller rockers sure did perform good when they were in my car.
|
 |
That round gold part is a titanium valve spring retainer being held on
with lock nuts allowing those bearings to spin.
|

|
Here you can see I cut some of the threads off that should bolt so they
sit flush with the wing-nut.
|

|
This is the underside of the project.
|

|
I had fun making this and might make more in the near future.
|
 |
1
2
3
4 |