|
Working With Wood
I made this end cap out of some wood that will go into the PVC.
|
|
I shot some black paint on it and now it's
ready to be pressed in.
|
|
This was an easy thing to make and didn't take that long. And I think it
looks much better now than it did before.
|
|
|
Installation
I'm in the back room at Open Door Escape Games getting ready to
install and test out the hand crank. My son-in-law made the
Jack-in-the-box and we're working on it here.
|
|
Here is a look on the inside and everything is installed. It's a simple
setup and it works really well. The motor runs on 12v DC and will be
hooked up to an electronic box to control it.
|
|
|
Here is what the box looks like inside the Escape Room all ready to be used.
They gave this box a distressed look because they didn't want anything
to look too nice. After all, this is suppose to be a scary game.
|
|
And here is the view from behind the gate that the players will see.
This was another fun project and I hope everyone will enjoy it when they
play this game.
|
 |
|
1
2
3 |
